Local Network Setup
Automatically Assign an IP address in to the DVR
All Zmodo DVR's have the capability of automatically assigning an IP address as long as the unit is connected to a router with an ethernet cord.
1) To auto assign an IP address in your DVR, access the Main Menu and go in to the Network Settings.
Select DHCP (auto assign IP) and select Apply. Restart the system after the setting has been saved.
H9104V, H9108V, H9116UVDH
2) Once the DVR boots back up, go back in to the Network Settings and write down the IP address, Gateway (router's IP), and all port numbers. Keep this information for the Remote Network Setup.
Checking Your Connection
3) Make sure the router is powered on.
4) Make sure the light on the router port that the eithernet cable is connected to is on.
5) Make sure the light on the DVR port is on.
7) Open Internet Explorer and enter the IP address of the DVR, to make sure you can see the login screen. If you can, your DVR is successfully communicating with your router.
8) After the confirming your connection, go back in to the Network Settings and change the Type back from DHCP to Static. Add 20 to the last set of digits in the IP address. Input this new IP address, Gateway (router's IP), and all port numbers. Save the settings and restart the DVR. This needs to be set to Static, otherwise, if your power goes out, your DVR may end up with a different IP address than the one that we will forward later on.
Your DVR can now be viewed over your local network.
Article ID: 97
Created On: Fri, May 4, 2012 at 12:25 AM
Last Updated On: Thu, Jun 14, 2012 at 2:00 PM
Online URL: http://kb.zmodo.com/article.php?id=97